
MPC-500 Tact Switches
April 6, 2019
Tact Switch Repair for the MPC500 MPC1000 and MPC2500
Fixing and replacing non-responsive tact switches can bring a dead worthless unit back to life. This does take a bit of skill as if your soldering level is not up to par you will ruin the board, and replacements are not cheap!
A good soldering iron station clone can be found for cheap, but don’t cheap out on your solder and parts.
We hope to have full MPC refresh kits up shortly for a fraction of the cost you would pay elsewhere, but for now, here is the DIY below.

Newer
MPC 500 Pad Upgrade DIY
You May Also Like

Rane TTM54 TTM52 Replacement Crossfader
August 20, 2022
PS3 Grill Mod
May 10, 2020
2 Comments
Mislav
What are the specs for lcd screen? There’s tons of cheap 16×2 lcd’s online but I’m not sure about the specs. Thank you!
admin
Any of the 5v 16 pin screens should work. I would recommend buying a few from different companies for testing purposes. I have a broken mpc500 that I use to test screens as I don’t think I would want to plug in a random screen in my good unit and have something go bad.